VidiEditor makes it possible for one to add transitions on segments at the beginning or end of a segment, as well as on a cut position between two segments. The following types of segments are supported:
Type
In
Out
Cut
Video cross dissolve
Fades from below layer
Fades to below layer
Fades between 2 segments
Video dip to black dissolve
Fades from below layer
Fades to below layer
Fades between 2 segments
Video dip to white dissolve
Fades from below layer
Fades to below layer
Fades between 2 segments
Audio cross dissolve
Fades from silent
Fades to silent
Fades between 2 segments
To add a dissolve, go to VidiEditor's effects panel and choose the desired transition. It can be selected from the effects pane listing available transitions.
It can then be used in the timeline composition by dragging it onto a valid segments position.
After which, the effect will be added with its default length configured in ConfigPortal (see Timeline Configuration Parameters [VE OG] ). It can be easily adjusted with trimming the transitions length directly on the timeline or setting the in / out in the settings pane after selecting a transition.
Please note: VidiEditor validates the needed meet when dropping the transition to a position. In case not enough media material is available it will reject adding the transition.
The result will be output in the timeline player after adding the transition to the timeline:
JavaScript errors detected
Please note, these errors can depend on your browser setup.
If this problem persists, please contact our support.
