Skip to main content
Skip table of contents

Creating a use case configuration [VF AgSDK]

In contrast to the (service) task contract that describes run-time input parameters for the task processor, a use case configuration allows to define "generic" input parameters that do not vary for every task execution.
In general, a use case configuration is used in the scope of an entire agent (e.g. REST endpoints for different tasks using the same REST resource) but can also be used for individual tasks or shared by different agents.
Note that the use case configuration will be published to VidiFlow's ConfigPortal when the agent is started. It might be necessary to refresh the ConfigPortal page to display it.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.